If you are in a level 1 view and set the top offset to level 2 the next.
Revit only shows 2 floors but the building has 3.
Click modify mass tabmodel panel mass.
At the prompt click yes to have revit lt rename the corresponding views.
Use the blue grip dot to drag the level head to the desired position.
Verify the detail level for the category of the element.
See override graphic display of element categories.
In addition to creating a level for each story in a building you can also create reference levels such as sill level.
Which suggests perhaps a setting somewhere.
A level s name helps you to identify what that datum represents be it a floor level underside of steelwork etc etc.
On the ribbon click level.
Create a scope box and apply it to the view.
After creating a mass for a conceptual design create a mass floor at each level defined in the project.
Given some walls that go from level 1 to level 2 and a floor at level 2 i have a project where these walls below show thru the floors in plan.
Orthographic views only adjust the position of the level head when the level is controlled by a scope box or a section box.
Each level in your project must have a unique name.
You are almost certainly going to want to change these default names to something more.
The top offset will default to the last used value e g.
For name enter 00 foundation and click ok.
Verify that the visibility of the object s category and subcategory are enabled.
In the project browser under floor plans right click level 2 and click rename.
Model categories can have detail level set independent of the view s detail level.
As you place the cursor to create a level if the cursor aligns to an.
By default revit will name these new levels level 1 level 2 level 3 and so on.
If you are in the level 3 plan view then the base constraint will be set to level 3.
Open the section or elevation view to add levels to.
If you have not already done so add levels to the project.
You can select the mass in any type of project view including floor plan rcp elevation section and 3d views.
That sounds like a nasty little endless loop.
Display a specific set of levels in the view and control their boundaries.
This isn t an underlay nor is it a transparent floor.
Architecture tabdatum panel level structure tabdatum panel level place the cursor in the drawing area and click.
Mass floors are based on levels defined in the project.
Alternatively you can rename levels by renaming the corresponding view in the project browser.
